Description
CPS is registered for the testing of relief valves up to 1600 bar of pressure, we have the capabilities to undertake IANZ endorsed tests of all makes and models of valves from very low pressure to over 1000 bar.
We can test using air or water and although we are mainly setup for the testing and certification of small relief valves but if you require a valve 2 inches or larger to be tested please contact us to discuss your requirements.
Each valve is lockwired, with a tag and an IANZ endorsed test report stating your required set pressure. We can undertake repairs and servicing as necessary. Onsite testing of relief valves is also available if required.
Historically this has been a growth business for CPS with our partners at Herose Valves being most prominent in our product line, complementing the relief valve testing service with our extensive range of German made Herose relief and safety valves.
This page is for the IANZ accredited testing of threaded relief valves larger than 2″, If you’re looking for IANZ accredited testing of smaller threaded valves, click here.
Product code:
Additional information
| Options Available | Our Herose Relief Valves 2 inch or larger, Relief Valve 2 inch or larger |
|---|
Technical Information
Technical Information
At CPS we have a number of methods for testing of relief valves.
Our main method is our own purpose built test rig for pressure from 0-70 bar using air as the medium. Connected to this is a special Dual line XP2i which allows CPS to see the Pop pressure as well as the correct line pressure which shows us if the valve hasn’t resealed, this gauge is connected into the main supply line so it reads the pressure as the air is being supplied to the valve.
For pressure over 70 bar we use our own CPS Comparator using water.
